Medieval Floors Marseille Collection Paris SPC 8mm
Why Visit Our Showroom?
For Contractors & Trade
Why Buy From Us?
Quick Answer
What is Marseille Collection Paris SPC 8mm?
Paris in the Marseille Collection is a warm light brown floor with a soft natural oak tone, printed in a wood-look over an SPC stone core. It is 100% waterproof, scratch-resistant, and stain-resistant, with a Limited Lifetime residential warranty behind it, so its relaxed look stands up to real daily use.
Is it waterproof?
Yes — 100% waterproof. Everyday spills, pet accidents, and mop water won't swell, warp, or delaminate the planks when wiped up promptly; standing water should still be cleaned up quickly. Not approved for outdoor installation; test the subfloor for moisture before installing.
Will it hold up to daily life?
Marseille Collection Paris SPC 8mm's 20 mil wear layer and finish are rated for pet claws, chair legs, dragged furniture, and heavy daily traffic — the scratch resistance that matters in kitchens, entryways, and pet households where foot and paw traffic concentrates.
What does the plank surface look like?
Each Paris plank shows open cathedral grain with delicate arches, fine straight grain lines, and scattered mineral marks, with no knots interrupting the flow. The surface is even, keeping the figure soft from board to board. As an 8mm Marseille plank, it has a 20 mil commercial wear layer over the SPC core.
Quiet enough upstairs or in a condo?
There's no separate underlayment to buy and no pad to choose. Marseille Collection Paris SPC 8mm's factory-attached 1.5mm IXPE anti-microbial acoustic pad comes bonded to every plank and dampens footfall noise throughout the home — one less material decision and one less install step.
Is it safe for indoor air?
Yes — Marseille Collection Paris SPC 8mm carries GREENGUARD Gold, FloorScore, Responsible Source (SCS Global) Certified, UNILIN, Lacey Act Compliant, Phthalate Free, EPA TSCA Title VI Compliant, CARB Phase 2 Compliant certifications, independently tested for low chemical emissions. That matters most for households with allergies, asthma, or young children.
Will this color work in my room?
Paris reads as an easy, oak-toned light brown that keeps a room bright and casual. In natural light the soft warmth comes through clearly; under lamps it stays gentle and unfussy. It pairs naturally with white and soft-white walls and welcomes bright accents like coral, which makes it a comfortable base for relaxed, everyday rooms.
Price range?
Marseille Collection Paris SPC 8mm runs $3 to $4 per square foot, material only. Plus CA sales tax. Trade pricing available for verified contractors, designers, and architects. Marseille Collection Paris SPC 8mm ships special-order in 3-7 business days; only the rotating set of colors on our sale page is stocked for immediate pickup. Call (408) 753-3220 for current quote.
Overview
Paris in the Marseille Collection is a light brown with a soft, natural oak tone that feels fresh and easy to live with. Delicate cathedral arches sweep across each board between fine straight grain lines and scattered mineral marks, giving the floor a relaxed, lived-in character rather than anything formal. We photographed it in a modern organic living room with a white sofa, a marble coffee table on dark legs, wildflowers, and a coral throw, all set over the oak-toned boards in natural side light. The 8mm Marseille build carries a 20 mil commercial wear layer and a 1.5mm acoustic underlayment, an easygoing profile suited to busy, casual rooms. Paris suits living rooms, family spaces, and everyday gathering spots that want a warm, approachable floor with a little natural movement.
A natural oak-toned light brown that keeps a family room fresh and easy.
Specifications
| Brand | Medieval Floors |
|---|---|
| Collection | Marseille Collection (8mm) |
| Color | Marseille Collection Paris SPC 8mm |
| Plank size | 9 inches wide × 60 inches long |
| Thickness | 8mm |
| Wear layer | 20 mil |
| Locking system | UNILIN |
| SF per carton | 18.8 sq ft |
| Installation grade | Above, On, Below grade |
| Waterproof | Yes — 100% |
| Warranty | Limited Lifetime Residential / 10 Years Commercial |
| Certifications | GREENGUARD Gold, FloorScore, Responsible Source (SCS Global) Certified, UNILIN, Lacey Act Compliant, Phthalate Free, EPA TSCA Title VI Compliant, CARB Phase 2 Compliant |
Installation
Marseille Collection Paris SPC 8mm's manufacturer installation specifications. Care follows in its own section.
Acclimation
Acclimate the planks 24-48 hours in a climate-controlled space; keep the room 65-85F for at least 48 hours before, during, and after installation. Store cartons flat, ends open, no more than 3-5 high.
Climate & humidity
Maintain a room temperature of 65-85F for at least 48 hours before, during, and after installation. Maintain indoor relative humidity between 40% and 70% after installation.
Subfloor flatness & prep
The substrate must be dry, clean, smooth, and flat - level within 3/16in over a 10-ft radius - and free of movement or deflection. Installs over wood, cured concrete, gypsum underlayment, or most existing single-layer hard-surface floors; never over carpet, cushioned-back resilient, or floating floors. New concrete slabs must cure for at least 90 days before installation.
Moisture testing
Concrete moisture vapor transmission must not exceed 8 lbs/1000 sq ft/24 hr (ASTM F-1869); internal relative humidity must not exceed 85% (ASTM F-2170).
Method
Installs as a glueless floating floor with an angle-tap click locking system; maintain a 5/16in (8.2mm) expansion gap at all walls and vertical objects, and stagger end joints a minimum of 8in. Indoor use only.
Underlayment
Planks have an attached underlayment - do not add a separate underlayment beneath them.
Radiant heat compatibility
Compatible with embedded radiant-heat subfloors (heating element at least 1/2in below the floor); run the system 21 days prior, turn it off 24 hours before and after installation, then raise the temperature gradually over 7 days. Maximum subfloor surface temperature is 85F.
Care & maintenance
Keeping Marseille Collection Paris SPC 8mm looking its best takes very little — the manufacturer care guidance is below.
Maintenance
Sweep or vacuum regularly with the beater bar off, and damp-mop with clean water and a vinyl-safe cleaner; wring out surplus water so the floor dries within a minute. Do not use polishes, waxes, or abrasive or ammonia-based cleaners.
Avoid
Rubber- or plastic-backed rugs (use felt), prolonged direct sunlight (use drapes or blinds), continuous indoor temperatures above 95F, abrasive or ammonia cleaners, and unclipped pet nails or untipped high heels.
Furniture protection
Use felt protectors under furniture legs and wide rubber casters with nonstaining mats under rolling chairs; slide a 1/8in Masonite sheet under heavy appliances when moving them.
Climate & humidity
Avoid prolonged direct sunlight; continuous indoor temperatures over 95F combined with strong sunlight can damage the floor.
Frequently asked questions
How do I estimate how much flooring I need?
Pro tip: don't return extras after install — colors can shift slightly between production runs. If you need 5 replacement planks in 2 years, your only exact match is the stock you kept. Bring floor-plan dimensions into the showroom and our staff will walk through the calculation with you.
Can I install SPC myself?
Most common case: DIY is allowed, but install mistakes (missed expansion gap, bad subfloor prep, wrong stagger, skipped moisture barrier) void that portion of coverage. Material defects from the manufacturer remain covered.
A few brands go further — their warranty requires "professional installation by a licensed contractor" as a coverage condition, so any DIY = warranty void even without mistakes. Check your brand's warranty language before deciding.
Pro tip: when a claim is filed, the manufacturer sends a licensed flooring inspector. DIY that followed manufacturer spec to the letter passes inspection; DIY that cut corners won't. We recommend: price out a licensed contractor quote first, read your warranty carefully, and decide based on your comfort with the procedure — not just labor savings.
Will it work in my basement?
Layer 1 — concrete moisture epoxy applied directly to the slab (manufacturer-approved liquid-applied membrane). Reduces vapor transmission well below the slab moisture limit this floor requires (measured per ASTM F1869 — see the Installation section for the exact figure).
Layer 2 — 6-mil polyethylene sheeting on the cured epoxy. The epoxy resists normal slab conditions; the plastic above is insurance against slab cracks from settling or seismic movement (common in older Bay Area homes built on fill). If the slab cracks in year 12, the plastic stops moisture before it reaches your SPC.
Cost: $600-1,100 for a typical basement vs $50-100 for plastic alone. For a floor lasting 20+ years in a moisture-prone slab, double protection pays for itself the first time the slab shifts.
How does SPC compare to real hardwood?
A genuine hardwood investment means solid hardwood, or engineered hardwood with 3mm+ veneer. That veneer thickness is the threshold where the floor becomes refinishable (2-3 refinishes over 50+ years, updated stain colors as trends shift). Appraisers factor genuine hardwood into home value; they don't factor SPC.
Caveat: budget engineered hardwood with 1-2mm veneer shares SPC's non-refinishable, 20-25 year practical life — but unlike SPC it is not waterproof, and unlike genuine hardwood with a 3mm+ veneer it cannot be refinished, so SPC stays the better pick for kitchens, baths, and basements. If you're paying hardwood prices, verify the veneer spec. Kapriz carries both categories; the right choice depends on your rooms and refinishing expectations.
Do you offer samples I can take home?
How fast does it ship?
What's your return policy?
Defective products are Kapriz's problem, not yours — manufacturing defects, wrong product, or transit damage documented on the delivery receipt all get free replacement or refund. Note any visible damage on the receipt before the driver leaves.
Why returns aren't standard: reverse logistics on a flooring pallet runs $300–800 with damage risk Kapriz absorbs.
Written exceptions (rare): 25% restocking fee + customer pays freight. Opened cartons, custom orders, and discontinued runs are never eligible.
Pro tip: unsure how Marseille Collection Paris SPC 8mm will look in your home? Call us — sample loan available (confirm Marseille Collection Paris SPC 8mm is in showroom; inventory rotates).