TYPES OF FLOORING BEHAVE DIFFERENTLY

Engineered floors behave somewhat differently than solid wood flooring. Although engineered wood flooring changes less dimensionally than solid wood flooring, engineered floors are notorious for developing gaps between the butt ends of boards. This is because most engineered wood flooring expands the same amount in all directions. The lengths of the boards are many times their width, which magnifies any dimensional change along the length. For this reason, it's important to leave the same amount of expansion clearance around the...

Read more...

CLEARANCE FOR SOLID WOOD FLOORING

How much clearance should be left between the wall and flooring generally coincides with the thickness of the flooring material. Typically, 3/4 in. of lateral movement is enough to pull the fasteners from the subfloor, so the National Wood Flooring Association (NWFA), the Wood Flooring Manufacturers Association (WFMA), and most manufacturers require a 3/4-in. expansion gap left in all vertical obstructions when installing 3/4-in.-thick solid wood flooring. This is a safe and simple rule across the grain, though it is...

Read more...

CONCEALING FLOORING EXPANSION

Solid wood flooring will expand or contract with any changes in its moisture content. The main issue isn't, as people tend to think, the floor pushing on the wall and buckling upward. That's primarily an aesthetic problem and, in fact, upward buckling is a sort of relief mechanism. The real concern is that if a floor gets wet and expands, it can exert sufficient pressure to move walls outward and create a structural problem. To address this concern, leave clearance between...

Read more...

KEEP THE SUBFLOOR FLAT

As well as being stiff, subfloors must be reasonably flat or areas of the wood floor would not consistently contact the subfloor, causing squeaks if fasteners don't suck the flooring down tight or adhesives aren't able to bridge the gaps. For wood flooring that requires fasteners l/^ in. or longer, the subfloor must be flat within 3/i6 in. over 6 ft. This is approxi­mately the thickness of two quarters and a penny together. Wood floor­ing installed using shorter fasteners or...

Read more...

CHECK THE SUBFLOOR INSTALLATION

Before installing (or even bringing) the wood flooring into the room, I inspect the subfloor to be certain it's up to par. With board subflooring, check to be sure the board ends are fully supported on joists and are fastened with at least two 8d ring-shank or rosin-coated nails per joist. If it's an old floor and the nails are loose, add more so the boards don't move. At the ends, the boards might need to be predrilled so new...

Read more...

PLYWOOD AND OSB SUBFLOORS

Structural wood panels such as plywood and oriented strand board (OSB) are the most common sub-floor materials today. Plywood is composed of thin sheets of veneer, or plies, laid up in cross-laminated layers to form a panel. Cross-lamination minimizes dimensional changes, making an extremely stable product. Plywood always has an odd number of layers, with the face layers' grain usually oriented parallel to the long dimension of the panel. Plywood is stronger along its length than its width so should always...

Read more...

SUBFLOORING MATERIAL

It's common to think of the stiffness of a floor as being simply a func­tion of the joists, but the joists work in concert with the subfloor. The subfloor helps to distribute point loads between multiple joists, and it stabilizes the joists so they don't roll under load. And whereas joists pro­vide strength and stiffness along their length, the subfloor provides these qualities between the joists. There are three main types of acceptable wood subflooring material: plywood, OSB, and solid boards....

Read more...

Subfloors: Stiff, Flat &Dry

All wood floors have one thing in common: they are only as good as the subfloor beneath them. There are gaps between the boards, and the floors always squeak when you walk on them. The reason? The builder installed the wood flooring over a subfloor consisting of one layer of V2-in. plywood. This subfloor isn't thick enough to hold the flooring nails, so the wood flooring moves constantly. This story is typical. Many flooring problems have more to do with what's...

Read more...

Installing wood flooring. HEARING PROTECTION

One in 10 Americans has a hearing loss severe enough to affect their ability to understand speech. It's more common among wood flooring contractors. Nearly everyone I know in this trade has hearing loss, which has made me all the more adamant about hearing protection. Noise is measured in decibels, or dB. The dB scale is logarithmic rather than linear. An increase of 10dB isn't additive; it represents a tenfold increase in noise. Consequently, even a small increase in dB can...

Read more...

Installing wood flooring. Safety Equipment Is Paramount.

Installing wood floors requires an incredible amount of cutting and nailing, but the most important equipment I own doesn't cut or fasten anything. Nothing comes before safety equipment. With all the cutting, nailing, and chemicals flooring installers work with, it is only a matter of time before an injury will occur if you don't have the proper protection. Many old-time wood flooring contractors are partially deaf because they didn't protect their hearing when using nailers and power tools. Before I started wearing...

Read more...

REMOVING OLD LINOLEUM OR VINYL FLOORS

You need to be careful when removing old resilient flooring. Many lino­leum and vinyl floors from the 1970s and earlier contained asbestos in their backings or adhesives. Various federal, state, and local government agencies have regulations that require special licensed abatement contrac­tors to remove material containing asbestos. (You can find these contrac­tors online or in the Yellow Pages.) I never remove old resilient flooring without having it tested for asbestos first. it is just not worth possible health problems, breaking...

Read more...

Removing existing floor Covering

If you're installing a hardwood floor in new construc­tion, all you have to worry about is the condition of the subfloor. But if you're working on a remodel project, you'll likely have to remove an existing floor covering, which might be carpet, linoleum, or vinyl. Removing old floor coverings is my least favorite part of installing wood flooring. REMOVING CARPET No matter how many times a carpet is cleaned throughout its life, removing all the animal dander, dirt, and dead bugs is...

Read more...

Wood Flooring Throughout the House

COLOR Wood flooring is available in a variety of colors that can change the feel of any room, making color one of the most critical aesthetic design elements. The palette of colors seems limitless. American walnut provides deep rich brown tones, hard maple has white with tan hues, and purpleheart really is purple. You can stain wood floors, but with the availability of so many colors, I generally try not to—when a stained floor is scratched, it can be hard to...

Read more...

STICKERING FLOORING BOARDS

Even Drying Promotes Straight, Flat Flooring. Because wood dries and shrinks first at the outside, the outer surfaces tend to be in tension while the inside is in compression. Keeping these forces balanced is crucial to keeping the wood flat and straight. That's why even air­flow is so important during acclimation. One edge drying faster than the other can result in crooked wood, because that edge exerts more tension on the board. Similarly, one face drying faster than another can cup...

Read more...

STORE FLOORING WHERE IT WILL BE INSTALLED

Not all wood flooring products should be acclimated. Some engineered products come wrapped in plastic, which keeps them at the manufacturer's desired moisture content until installation. The tongue-and-groove joint in these products is precisely machined, and moisture changes can make it too tight and hard to fit. Wood flooring may, or may not, be delivered at the correct moisture content to be installed in a particular house. Even the most reputable seller can only control the moisture of the flooring while...

Read more...

Hardwood floors

Natural beauty of wood makes it the one of favourite materials. Hardwood Flooring has a great variety of options. The choice depends on whether it is supposed to re-do a floor, to repair existing or to install a new hardwood flooring over an old floor. Natural aging of a wood only improves the appeal and it's type. Sound of steps and noise of the removed chairs or other furniture can be heard in the room on the floor below — it is well known to people who lives in apartments or...

Read more...

Types of rolled flooring

The most popular types of rolled flooring is carpet (including natural carpet), sinthetic -  made of polyvinylchloride (PVC) and linoleum. For carpets both  materials can be used : natural and synthetic, plus their mixes. Most popular are  -  synthetic carpets becayse of their wear resistance. Polyester, polyacryle, polypropylene, nylon — the market is rich with the offers. From the point of view of an ease of care, color fastness, than softness (but a creaseresistance) one of the best is nylon. Its only minus — high...

Read more...

Reasons and methods of elimination of scratch of a floor

Many inhabitants of old houses face a problem of the fact that the deal wooden floor begins to creak over time. Such floors usually lie on the logs which are over a concrete plate, eventually become loose and when walking on them begin to creak. Especially it becomes noticeable and irritates at night when you try to pass quietly about the room and to a corridor, a floor creaks, and you finally awake relatives. Basic reasons of that scratch of floors If...

Read more...

What kind of underlay to select for laminate flooring?

The number of admirers of a laminate grows every day. Installing the laminate doesn't demand special skills as connection of plates happens at the expense of the special lock so you can do it yourself. Before installation it is necessary to clean the floor to avoid the formation of dust. Then put the underlay before starting installing the laminate flooring. It is desirable to stack an underlay perpendicular to the direction of  a laminate. It will allow to avoid coincidence of joints at an...

Read more...

How to close a joint between a tile and a laminate

Today the laminate is the most urgent and demanded flooring which can be used almost everywhere in the house or apartment. However, using it in the hall or kitchen it isn't very practical and it is reasonable decision. For such rooms the ceramic tile will be the best option. However laminate in the  kitchen can be used in the dining area, and other part of the room can be covered with tile. And here is a question: how to close a joint between a tile...

Read more...