Serendipity SPC Flooring 9-inch Wide Bastrop 207 Ceramic Bead Finish
Why Visit Our Showroom?
For Contractors & Trade
Why Buy From Us?
Quick Answer
What is Bastrop 207?
Bastrop 207 is a deep warm brown with reddish undertones and golden streaking — the darkest, boldest color in the Serendipity line. It is a wood-look print over an SPC stone-polymer core, built to keep that rich, dramatic tone in a high-traffic room. The grain is an open cathedral pattern with sweeping ribbon figure, so the color shows real depth and movement rather than a single flat brown.
Is it waterproof?
Yes — 100% waterproof. Survives dishwasher leaks, pet accidents, mop water, and burst pipes without swelling, warping, or delaminating. Not approved for outdoor installation; test the subfloor for moisture before installing.
Will it hold up to daily life?
Bastrop 207's 20 mil wear layer and Ceramic Bead finish are rated for pet claws, chair legs, dragged furniture, and heavy daily traffic — the scratch resistance that matters in kitchens, entryways, and pet households where foot and paw traffic concentrates.
What does the plank surface look like?
Each plank is 9 inches wide and 60 inches long, a generous board that lets the sweeping ribbon figure and flowing arcs run their full length. The surface shows long mineral streaks along the grain, scattered pin knots, and strong board-to-board variation, so no two boards repeat the same pattern. A Larger Micro Bevel edge defines each plank, and the Ceramic Bead finish adds scratch and scuff resistance across the printed surface.
Quiet enough upstairs or in a condo?
There's no separate underlayment to buy and no pad to choose. Bastrop 207's factory-attached 1.5mm IXPE antimicrobial acoustic pad comes bonded to every plank and dampens footfall noise throughout the home — one less material decision and one less install step.
Is it safe for indoor air?
Yes — Bastrop 207 is GREENGUARD Gold, FloorScore certified, independently tested for low chemical emissions. That matters most for households with allergies, asthma, or young children.
Will this color work in my room?
This is a dark floor, so it suits rooms with light to spare or a deliberate high-contrast scheme. Against white walls, pale furniture, and bright daylight, Bastrop 207 reads as a confident, deep base that makes lighter pieces stand out. In a smaller or dim room it will read closer and cozier, which some people want and others don't — if you like an airy look, pair it with plenty of white and natural light. The golden streaking keeps the brown warm rather than cold, so it leans inviting, not severe.
Price range?
Bastrop 207 runs $2 to $3 per square foot, material only. Plus CA sales tax. Trade pricing available for verified contractors, designers, and architects. Bastrop 207 is in stock — pick up at our Santa Clara showroom or get fast Bay Area delivery. Call (408) 753-3220 for current quote.
Overview
Bastrop 207 is the deep, dramatic end of the Serendipity line — a wood-look print over a stone-polymer core in a deep warm brown with reddish undertones and golden streaking. It is the darkest color in the brand, and it looks the part: an open cathedral grain runs in sweeping ribbon figure and flowing arcs, with long mineral streaks and strong board-to-board variation that give a dark floor real movement instead of a flat slab of color. In a contemporary-minimal living room, Bastrop 207 works as the deliberate dark base of the space, pulling visual weight against white walls, a white sectional, and tan leather so the room feels balanced without going heavy. The planks are 9 inches wide by 60 inches long at 6mm thick, with a 20 mil wear layer and a Ceramic Bead finish that adds scratch and scuff resistance — useful on a dark tone, where everyday wear shows soonest. The core is 100% waterproof, so Bastrop 207 suits the rooms most floors avoid: open living areas, entryways, and below-grade spaces. To get the most from the ribbon variation, pull planks from at least five boxes as you lay them.
The darkest color in the line, with sweeping ribbon grain that keeps a deep brown floor from ever looking flat.
Specifications
| SKU | 207 |
|---|---|
| Brand | Serendipity Collection Floors |
| Collection | 6MM SPC SERIES |
| Color | Bastrop 207 |
| Plank size | 9 inches wide × 60 inches long |
| Thickness | 6mm |
| Wear layer | 20 mil |
| Edge profile | Larger Micro Bevel |
| Finish | Ceramic Bead |
| Locking system | Uniclic |
| SF per carton | 26.3 sq ft |
| Installation grade | Above, On, Below grade |
| Waterproof | Yes — 100% |
| Warranty | 50 Years Residential / 10 Years Light Commercial |
| Certifications | GreenGuard Gold, FloorScore |
Installation
Bastrop 207's manufacturer installation specifications. Care follows in its own section.
Installation method
Acclimate the planks 24 to 48 hours in a climate-controlled job site before installation. Store cartons flat (never on edge), no more than 5 boxes high, to protect the locking system. These planks are a floating floor and should not be glued or nailed to the substrate; they are for indoor use only. Leave a minimum 5/16-inch expansion space around the perimeter and all vertical objects. Stagger end joints a minimum of 8 inches from row to row. Pull alternate planks from at least 5 boxes to blend natural color and texture variation. Do not install cabinets on top of the planks.
Climate & humidity
Maintain a room temperature of 65F to 85F for at least 48 hours before, during, and after installation. Post-installation flooring temperature must be maintained between 65F and 100F.
Subfloor flatness & prep
A wood subfloor must be smooth, flat, and free of movement; if joist spacing exceeds 19.2 inches on center, a minimum 3/4-inch total subfloor thickness is required. May be installed over on-, above-, or below-grade concrete; a new concrete slab must cure at least 90 days. May be installed over most smooth, single-layer, uncushioned hard-surface floors; do not install over carpet or cushioned-back resilient flooring.
Moisture testing
Concrete moisture vapor transmission must not exceed 8 lbs/1000 sq ft/24 hours (ASTM F-1869); internal relative humidity must not exceed 85% (ASTM F-2170). In crawl spaces, keep exposed earth 100% covered with a minimum 6-8 mil black polyethylene vapor barrier, joints overlapped and sealed.
Radiant heat compatibility
Can be installed over embedded radiant-heated subfloors; the maximum subfloor surface temperature over radiant heat is 85F; run radiant heat 21 days before, off 24 hours before and after, then raise gradually over 7 days.
Care & maintenance
Keeping Bastrop 207 looking its best takes very little — the manufacturer care guidance is below.
Climate & humidity
Maintain interior relative humidity between 30% and 50% year-round. Avoid prolonged direct sunlight; use drapes or blinds during peak hours, as continuous indoor temperatures over 95F with strong sunlight can damage the floor.
Daily maintenance
Sweep or vacuum regularly with the beater bar turned off. Wipe spills with clean water and a damp (not wet) mop, then dry-mop off surplus water so residual water evaporates within one minute. Use only cleaners recommended for vinyl flooring; do not use polishes, waxes, or abrasive or ammonia-based cleaners. These planks are waterproof; after flooding, remove the water promptly and run a dehumidifier to return moisture to normal levels. Remove stubborn scuff marks with a tennis ball or pencil eraser, rubbing gently in the long direction of the plank.
Pets & claws
Keep pet nails clipped, as claws can scratch the finish; place a mat between a pet water dish and the floor.
Furniture protection
Use only rugs with a natural felt backing; rubber or abrasive backings can damage or discolor the floor. Use felt protectors under furniture legs; slide a 1/8-inch Masonite sheet under heavy appliances when moving them; caster chairs need wide rubber casters over a non-staining mat.
Frequently asked questions
How do I estimate how much flooring I need?
Pro tip: Don't shortchange the 10% buffer. If you end up with 3-5 extra cartons, keep them — don't return them. Even if you reorder the same SKU in 3 months, it'll be a different manufacturing batch with slightly different tone and grain. It won't match your existing floor. The extras are insurance against leaks, furniture damage, or cracks down the road.
Can I install SPC myself?
Most common case: DIY is allowed, but install mistakes (missed expansion gap, bad subfloor prep, wrong stagger, skipped moisture barrier) void that portion of coverage. Material defects from the manufacturer remain covered.
A few brands go further — their warranty requires "professional installation by a licensed contractor" as a coverage condition, so any DIY = warranty void even without mistakes. Check your brand's warranty language before deciding.
Pro tip: when a claim is filed, the manufacturer sends a licensed flooring inspector. DIY that followed manufacturer spec to the letter passes inspection; DIY that cut corners won't. We recommend: price out a licensed contractor quote first, read your warranty carefully, and decide based on your comfort with the procedure — not just labor savings.
Will it work in my basement?
Layer 1 — concrete moisture epoxy applied directly to the slab (manufacturer-approved liquid-applied membrane). Reduces vapor transmission well below the 8 lbs/1000sqft/24hr ceiling most SPC products tolerate (measured per ASTM F1869).
Layer 2 — 6-mil polyethylene sheeting on the cured epoxy. The epoxy resists normal slab conditions; the plastic above is insurance against slab cracks from settling or seismic movement (common in older Bay Area homes built on fill). If the slab cracks in year 12, the plastic stops moisture before it reaches your SPC.
Cost: $600-1,100 for a typical basement vs $50-100 for plastic alone. For a floor lasting 20+ years in a moisture-prone slab, double protection pays for itself the first time the slab shifts.
How does SPC compare to real hardwood?
A genuine hardwood investment means solid hardwood, or engineered hardwood with 3mm+ veneer. That veneer thickness is the threshold where the floor becomes refinishable (2-3 refinishes over 50+ years, updated stain colors as trends shift). Appraisers factor genuine hardwood into home value; they don't factor SPC.
Caveat: budget engineered hardwood with 1-2mm veneer shares SPC's non-refinishable, 20-25 year practical life — but unlike SPC it is not waterproof, and unlike genuine hardwood with a 3mm+ veneer it cannot be refinished, so SPC stays the better pick for kitchens, baths, and basements. If you're paying hardwood prices, verify the veneer spec. Kapriz carries both categories; the right choice depends on your rooms and refinishing expectations.
Do you offer samples I can take home?
How fast does it ship?
What's your return policy?
Always covered at no cost: manufacturing defects, wrong product shipped, delivery damage documented on receipt. Call (408) 753-3220 to report.
Why not returnable by default: reverse freight on a pallet runs $300–800 with damage risk through 6 handoffs — Kapriz carries that exposure.
Rare written exceptions: 25% restocking fee + customer pays freight. Never for opened cartons, custom orders, or discontinued runs.
Pro tip: call (408) 753-3220 to arrange a sample loan before a large order — confirm the color is in the showroom (inventory rotates).







