Gaia Floors eTerra Red Series Torino GA805313 SPC 8mm 9-inch
Why Visit Our Showroom?
For Contractors & Trade
Why Buy From Us?
Quick Answer
What is Torino?
Torino is a warm medium-brown wood-look floor with a soft amber depth that keeps it from reading flat or cool. The print captures open cathedral grain with long sweeping arcs, scattered cat's-eye knots, and fine mineral flecking, so each board carries a little natural character rather than a single repeating pattern.
Is it waterproof?
Yes — 100% waterproof. Powder-room splashes, daily wet feet, and towel drops wipe up without harm when cleaned promptly. Indoor use only — not for installation inside showers or wet rooms, and outdoor installation is not approved.
Will it hold up to daily life?
Kitchen stress test: dropped cutlery, pans slid from oven to counter, refrigerator casters, and dishwasher spray — Torino's 20 mil wear layer and UV-cured ceramic bead (EnduraPro) finish handle the spills, dropped pots, and dragged stools of daily kitchen use, and wipe clean with a pH-neutral cleaner.
What does the plank surface look like?
Up close the plank surface shows open cathedral grain with flowing figure and long arcs, plus a few medium cat's-eye knots with dark centers and fine mineral flecking along the grain. The print sits under a UV-cured ceramic-bead finish, so the texture you see reads as natural wood-tone variation board to board rather than a glossy, uniform sheet.
Quiet enough upstairs or in a condo?
There's no separate underlayment to buy and no pad to choose. Torino's factory-attached IXPE antimicrobial sound-deadening acoustic pad comes bonded to every plank and dampens footfall noise throughout the home — one less material decision and one less install step.
Is it safe for indoor air?
Yes — Torino is FloorScore, GREENGUARD Gold certified, independently tested for low chemical emissions. That matters most for households with allergies, asthma, or young children.
Will this color work in my room?
This is a true mid-tone, so Torino works in most rooms without forcing the rest of the palette one way. The warm amber undertone pairs easily with cream, off-white, and soft neutral furnishings, and it gives a calm, airy feel under daylight while still holding its warmth in the evening.
Price range?
Material cost: $4 to $5 per square foot. Installation is separately quoted by your flooring contractor — Kapriz refers vetted licensed pros. Plus CA sales tax. Trade pricing for Torino and full catalog available for contractors, designers, architects.
Overview
Torino is a warm medium brown with a soft amber depth, a wood-look print pressed over a rigid stone-polymer core. The grain reads as open cathedral figure with long sweeping arcs down each board, broken by scattered cat's-eye knots with dark centers and fine mineral flecking along the gentle ribbon. It is a calm, airy mid-tone that suits open living rooms, dining areas, and bright everyday spaces where you want warmth without going dark. Because Torino is built on an SPC core with a 20 mil wear layer and a UV-cured ceramic-bead finish, it resists scratches and stands up to daily foot traffic, and it is waterproof against spills that are wiped up promptly. Come see how the amber depth of Torino reads at our Santa Clara showroom on Laurelwood Rd, where the Bay Area light shifts from foggy morning to golden-hour sun.
A warm medium brown with amber depth and open cathedral grain, built to take real daily wear.
Specifications
| SKU | GA805313 |
|---|---|
| Brand | Gaia Floor |
| Collection | eTerra Red Series |
| Color | Torino |
| Plank size | 9 inches wide × 60 inches long |
| Thickness | 8mm |
| Wear layer | 20 mil |
| Finish | UV-cured ceramic bead (EnduraPro) |
| Locking system | Valinge 5G drop-down |
| SF per carton | 18.86 sq ft |
| Installation grade | Above, On, Below grade |
| Waterproof | Yes — 100% |
| Warranty | 50 Years Residential / 10 Years Light Commercial limited warranty (prorated after the first 5 residential years). Covers manufacturing defects, the UV-cured ceramic-bead finish, and topical waterproof protection under normal use. Non-transferable; original purchaser, single-site installation. |
| Certifications | FloorScore, GREENGUARD Gold |
Installation
Torino's manufacturer installation specifications. Care follows in its own section.
Installation method
These planks install as a glueless floating floor and may be laid over most existing clean, dry, level hard-surface coverings. For indoor, climate-controlled use only; not suitable for sun-rooms, solariums, showers, saunas, seasonal porches, RVs, boats, or any space with flooding potential. Acclimate the planks a minimum of about 12 hours on site before installation. Maintain a 1/4" expansion gap to walls and fixed construction such as pillars, cabinets, and islands. Install T-moldings in doorways 4 ft or narrower and in rooms 49 ft or longer in any direction. The acoustic pad is attached to the plank, so no additional underlayment should be added. Inspect every plank under good lighting before installation and discard pieces with questionable color, finish, or sheen; report visual defects within 15 days. Purchase about 5% extra material for back stock and future replacements.
Climate & humidity
Install in conditions of 35-55% relative humidity and a room temperature of 60-80°F, and keep three-season rooms within that range year-round.
Subfloor flatness & prep
The sub-floor must be flat within 3/16" over 10 ft (or 1/8" over 6 ft) and securely anchored. Concrete sub-floors must be ASTM F710 compliant, at least 3,000 psi in density, with a pH of 9 or below.
Moisture testing
Concrete must test at no more than 80% relative humidity (ASTM F2170) and no more than 3 lbs/1000 sq ft/24 hr (ASTM F1869). New concrete or gypcrete must cure and dry a minimum of 4 weeks before installation. A vapor barrier is required over all concrete sub-floors: 6 mil polyethylene with an 8" overlap.
Radiant heat compatibility
Compatible with radiant heat as long as the floor surface temperature never exceeds 80°F (26.67°C). Keep at least 1/2" of separation between heating elements and the flooring, and an in-floor temperature sensor is recommended. Raise or lower radiant heat gradually, about 10°F per day, and never shut it off abruptly.
Care & maintenance
Keeping Torino looking its best takes very little — the manufacturer care guidance is below.
Daily maintenance
Vacuum or sweep regularly to remove grit, but do not use vacuums with beater bars or power rotary brush heads. Clean spills quickly with a luxury vinyl cleaner and a clean white cloth, mopping back-and-forth and replacing the mop cover when soiled. Use a pH-neutral cleaner; no waxing is required. Avoid steam cleaners, spray cleaners, and any device that sprays liquid directly on the floor, as water can cause damage. Never use oil soaps, wax, liquid detergent, or other household products, and avoid excessive wet mopping and standing water. Place exterior and interior entry mats at all entrances, but avoid rubber-backed mats, which can stain the floor or trap moisture.
Furniture protection
Use felt or plastic floor protectors at least 1" in diameter under furniture legs. Chairs with wheeled casters need flat 1"-wide casters and a protective rigid mat; rubber casters are preferred over plastic or metal. Use a dolly to move heavy furniture or appliances; never slide or roll heavy items across the floor.
Pets & claws
Trim pets' nails and inspect footwear for spiked heels to protect the finish.
Climate & humidity
Minimize direct sunlight and intense lighting by keeping window treatments closed when sunlight is strong.
Radiant
Use caution with area rugs over radiant heating, as they can raise the floor temperature beyond recommended levels.
Frequently asked questions
How do I estimate how much flooring I need?
Pro tip: Don't shortchange the 10% buffer. If you end up with 3-5 extra cartons, keep them — don't return them. Even if you reorder the same SKU in 3 months, it'll be a different manufacturing batch with slightly different tone and grain. It won't match your existing floor. The extras are insurance against leaks, furniture damage, or cracks down the road.
Can I install eSPC myself?
Most common case: DIY is allowed, but install mistakes (missed expansion gap, bad subfloor prep, wrong stagger, skipped moisture barrier) void that portion of coverage. Material defects from the manufacturer remain covered.
A few brands go further — their warranty requires "professional installation by a licensed contractor" as a coverage condition, so any DIY = warranty void even without mistakes. Check your brand's warranty language before deciding.
Pro tip: when a claim is filed, the manufacturer sends a licensed flooring inspector. DIY that followed manufacturer spec to the letter passes inspection; DIY that cut corners won't. We recommend: price out a licensed contractor quote first, read your warranty carefully, and decide based on your comfort with the procedure — not just labor savings.
Will it work in my basement?
Layer 1 — concrete moisture epoxy applied directly to the slab (manufacturer-approved liquid-applied membrane). Reduces vapor transmission well below the slab moisture limit this floor requires (measured per ASTM F1869 — see the Installation section for the exact figure).
Layer 2 — 6-mil polyethylene sheeting on the cured epoxy. The epoxy resists normal slab conditions; the plastic above is insurance against slab cracks from settling or seismic movement (common in older Bay Area homes built on fill). If the slab cracks in year 12, the plastic stops moisture before it reaches your eSPC.
Cost: $600-1,100 for a typical basement vs $50-100 for plastic alone. For a floor lasting 20+ years in a moisture-prone slab, double protection pays for itself the first time the slab shifts.
How does eSPC compare to real hardwood?
A genuine hardwood investment means solid hardwood, or engineered hardwood with 3mm+ veneer. That veneer thickness is the threshold where the floor becomes refinishable (2-3 refinishes over 50+ years, updated stain colors as trends shift). Appraisers factor genuine hardwood into home value; they don't factor eSPC.
Caveat: budget engineered hardwood with 1-2mm veneer shares eSPC's non-refinishable, 20-25 year practical life — but unlike eSPC it is not waterproof, and unlike genuine hardwood with a 3mm+ veneer it cannot be refinished, so eSPC stays the better pick for kitchens, baths, and basements. If you're paying hardwood prices, verify the veneer spec. Kapriz carries both categories; the right choice depends on your rooms and refinishing expectations.
Do you offer samples I can take home?
How fast does it ship?
What's your return policy?
Always covered at no cost: manufacturing defects, wrong product shipped, delivery damage documented on receipt. Call (408) 753-3220 to report.
Why not returnable by default: reverse freight on a pallet runs $300–800 with damage risk through 6 handoffs — Kapriz carries that exposure.
Rare written exceptions: 25% restocking fee + customer pays freight. Never for opened cartons, custom orders, or discontinued runs.
Pro tip: call (408) 753-3220 to arrange a sample loan before a large order — confirm the color is in the showroom (inventory rotates).